HP Victus 16z-e000 - Memory Modules; Prepare the Computer for Disassembly (See Preparation for Disassembly

3. When installing a solid-state drive, be sure to install a thermal pad onto the bracket as shown in the
following illustration.
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-2 Memory module descriptions and part numbers
Description Spare part number
Memory module, 16 GB (DDR4-3200) L67710-001
Memory module, 8 GB (DDR4-3200) L46598-001
Memory module, 4 GB (DDR4-3200) L83673-001
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 33).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Disconnect the battery cable from the system board (see Battery on page 38).
If you are replacing a memory module, remove the existing memory module:
▲ Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT: To prevent damage to the memory module, hold the memory module by the edges only.
Do not touch the components on the memory module.
Component replacement procedures 35