3. You can remove the camera with the display assembly connected to the computer. If you need to remove
the camera module:
a. Use a tool to detach the camera module (1) from the display back cover. (The module is attached
with double-sided adhesive.)
b. Disconnect the cable from the module (2). Note that the cable routes under the module. The
camera module is available as spare part number M54726-001.
4. The remaining display components require that you remove the display assembly from the computer. To
remove the display assembly:
a. Remove the seven Phillips M2.5 × 3.5 screws (1) that secure the display assembly to the computer.
b. Remove the two Phillips M2.0 × 5.0 screws (2) that secure the display assembly to the computer.
c. Open the display to open the hinges (3).
56 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
