HP VSR1000 - Displaying and Maintaining Track Entries; Track Configuration Examples; VRRP-Track-NQA Collaboration Configuration Example

62
Step Command Remarks
2. Create a policy or policy
node and enter PBR policy
node view.
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
N/A
3. Define a match criterion.
• Define an IPv6 packet length match
criterion:
if-match packet-length min-len max-len
• Define an ACL match criterion:
if-match acl { acl6-number | name
acl6-name }
By default, no packets
are filtered.
4. Associate Track with IPv6
PBR.
• Set the outgoing interface, and associate it
with a track entry:
apply output-interface { interface-type
interface-number [ track
track-entry-number ] }&<1-n>
• Set the next hop, and associate it with a
track entry:
apply next-hop [ vpn-instance
vpn-instance-name | inbound-vpn ]
{ ipv6-address [ direct ] [ track
track-entry-number ] }&<1-n>
• Set the default outgoing interface, and
associate it with a track entry:
apply default-output-interface
{ interface-type interface-number [ track
track-entry-number ] }&<1-n>
• Set the default next hop, and associate it
with a track entry:
apply default-next-hop [ vpn-instance
vpn-instance-name | inbound-vpn ]
{ ipv6-address [ direct ] [ track
track-entry-number ] }&<1-n>
Use at least one of the
commands.
Displaying and maintaining track entries
Execute display commands in any view.
Task Command
Display information about a specific or all track entries. display track { track-entry-number | all }
Track configuration examples
VRRP-Track-NQA collaboration configuration example
In this example, the master monitors the uplink.