EasyManuals Logo
Home>HP>Server>X510 - StorageWorks Data Vault

HP X510 - StorageWorks Data Vault Manual

HP X510 - StorageWorks Data Vault
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
English
7
Batteries are delivered with this product. When
empty, do not throw them away but collect as
small chemical waste.
FCC Regulatory and Safety
Information (USA Only)
Modifications
The FCC requires the user to be notified that any
changes or modifications made to this device
that are not expressly approved by Hewlett-
Packard Company may void the user's authority
to operate the equipment.
Cables
Connections to this device must be made with
shielded cables with metallic RFI/EMI connector
hoods in order to maintain compliance with FCC
Rules and Regulations.
WARNING: Please read the
Additional Safety
Information” located later in
this document before installing
and connecting your HP Data
Vault to the electrical power
system.
WARNING: The HP Data Vault
uses a lithium battery, type
CR2032. There is danger of an
explosion if the battery is
incorrectly replaced. Replace
only with the same, or
equivalent, type recommended
by the manufacturer. Dispose
of used batteries according to
the manufacturer’s
instructions.
WARNING: This equipment has
been tested and found to
comply with the limits for a
Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to
provide reasonable protection
against harmful interference in
a residential installation. This
equipment generates, uses,
and can radiate radio
frequency energy and, if not
installed and used in
accordance with the
instructions, may cause
harmful interference to radio
communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user
is encouraged to correct the
interference by one or more of
the following measures:
Reorient or relocate the
receiving antenna.
Increase the separation
between the equipment and
the receiver.
Connect the equipment into
an outlet that is on a circuit
different from the receiver.
Consult the dealer or an
experienced radio/TV
technician for help.

Other manuals for HP X510 - StorageWorks Data Vault

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP X510 - StorageWorks Data Vault and is the answer not in the manual?

HP X510 - StorageWorks Data Vault Specifications

General IconGeneral
BrandHP
ModelX510 - StorageWorks Data Vault
CategoryServer
LanguageEnglish

Related product manuals