Front fan and fan holder installation
Introduction
This document describes how to install a front card guide and front fan in the HP xw and HP
Workstation series.
Kit contents
●
Warranty information
●
Fan
●
Fan holder for HP xw9300 Workstations
●
Combination card guide/fan holder for the HP xw6000 Workstation series
●
Combination card guide/fan holder for the HP xw4000 Workstation series and HP
400
Workstations
Before you begin
To view QuickSpecs and determine the compatibility of this product with your HP workstation, see
http://www.hp.com/go/productbulletin.
NOTE: Only workstations having non-factory-integrated, high power PCI cards require the additional
cooling provided by the optional front chassis fan included in this kit. The optional front chassis fan is
not recommended for use on workstations that have hard drives mounted in the optical bays because
this might reduce long term reliability of these hard drives. HP recommends that your environmental
temperature not exceed 27°C (80°F) if this fan is installed in your workstation and you have hard drives
installed in the optical bay area.
© 2004–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW Introduction 1
To Next Page
Need help?
General
