LSI MegaRAID® SAS 8888ELP Host Bus
Adapter installation
Introduction
This document describes how to install the LSI MegaRAID® SAS 8888ELP Host Bus Adapter (HBA) in
HP
and xw series Workstations. Procedures are included for connecting SAS hard drives mounted
in hard drive bays and optical drive bays to the Redundant Array of Independent Drives (RAID) controller
card.
Kit contents
●
SAS RAID controller card
●
MiniSAS 4i to 4X SATA internal adapter cable (short)
●
4-Port data cable with 90-degree connectors (long)
●
4-Port data cable with straight connectors (long)
●
CD with software drivers and manufacturer's documentation
●
Hard drive activity LED cable
●
Installation instructions (this document)
●
Warranty information
Before you begin
To view QuickSpecs and determine the compatibility of this product with your HP workstation, see
http://www.hp.com/go/productbulletin.
© 2007–2009 Hewlett-Packard Development Company, L.P. MegaRAID is a registered
trademark of LSI Corporation. Printed in the U.S.
ENWW Introduction 1
To Next Page
Need help?
General
