Rack mount tray installation
Introduction
This document describes how to install the HP Z200 and Z210, Z400, and xw4000 series
Workstations into a rack mount tray. It also describes how to mount the workstation-tray assembly into
a rack.
Kit contents
●
Rack mount tray
●
Adapter brackets
●
Rails and mounting hardware (installation instructions in Appendix A of this document)
●
Installation instructions
●
Warranty information
Required tools
●
T-15 Torx screwdriver
●
T-20 Torx screwdriver
●
Cross-tip screwdriver
© 2011 Hewlett-Packard Development Company, L.P. Printed in the U.S.
ENWW
Introduction
1
To Next Page
