Chapter 7: Using Directory Mode on page 161—Establishing RGS connections using Directory
Mode is described in this chapter.
Chapter 8:
RGS properties on page 165—This chapter describes each of the RGS Sender and
Receiver properties.
Chapter 9:
Sender event logging on Windows on page 195—This chapter describes the Windows
Event Logging capability of RGS.
Chapter 10:
Remote Application Termination on page 200—This chapter describes how the
Windows Event Logging capability of RGS can be used to terminate applications if a desktop session is
left running without supervision.
Chapter 11:
Optimizing RGS performance on page 215—This chapter provides a number of
suggestions to optimize RGS performance.
Chapter 12:
Troubleshooting RGS on page 219—This chapter describes how to troubleshoot issues
related to establishing an RGS connection, network timeouts, graphics performance, remote audio, and
remote USB.
Chapter 13:
RGS error messages on page 220—This chapter lists each of the errors reported by the
RGS Receiver and describes their probable cause.
Appendix B:
USB devices supported by RGS on page 223—This appendix lists the USB devices that
are supported by RGS. Note that, prior to RGS 5.2.0, this list was maintained in a separate document
—this list is now integrated into this document as Appendix B.
Appendix C:
Linux remote audio device support on page 230—This appendix provides information
on audio devices that are supported on Linux-based Remote Computers.
NOTE: For a version of the HP RGS 5.4.7 User Guide that may be more current than this document,
visit the HP website
http://www.hp.com/support/rgs_manuals.
For release-specific information, refer to the release notes that are provided with the RGS product.
For additional HP RGS product information, visit the RGS homepage at
http://www.hp.com/go/rgs
2 Chapter 1 Introduction to HP Remote Graphics Software
To Next Page
Loading...
