HP Z620 - Page 203

Rgreceiver.Session.<N>.RemoteDisplayWindow.X.IsMutable=bool （1）
This property specifies the X position of the session N Remote Display Window, as measured from the
left side of the Local Computer display.
Rgreceiver.Session.<N>.RemoteDisplayWindow.Y=int （0）
Rgreceiver.Session.<N>.RemoteDisplayWindow.Y.IsMutable=bool （1）
This property specifies the Y position of the session N Remote Display Window, as measured from the
top of the Local Computer display.
Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled=bool （0）
Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled.IsMutab
le=bool（1）
This property, if set true (1), enables the following preferred resolution property values to be
communicated to the Remote Computer. The default value is 0—do not enable the preferred resolution
property to be communicated to the Remote Computer.
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionHeight=int （0）
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionHeight.IsMutable=
bool （1）
See the description of the following property.
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionWidth=int （0）
Rgreceiver.Session.<N>.VirtualDisplay.PreferredResolutionWidth.IsMutable=b
ool （1）
This property and the above property specify the preferred resolution of the Remote Display Window
(in pixels). This resolution is communicated to the Remote Computer Sender, which will attempt to adapt
its resolution to match the resolution preference of the Local Computer. If the Remote Computer is
unable to match the resolution preference of the Local Computer, a warning dialog is displayed on the
Local Computer
NOTE: The per-session property Rgreceiver.Session.<N>.VirtualDisplay.IsPreferredResolutionEnabled
takes precedence over the per-Receiver property Rgreceiver.IsMatchReceiverResolutionEnabled. This
allows individual sessions to override the global property.
RGS Receiver properties
187