HP Z620 - Page 205

◦
Rgsender.IsDisconnectOnLogoutEnabled
◦
Rgsender.MaxImageUpdateRate
◦
Rgsender.ImageCodec.Preferred
◦
Rgsender.IsBlankScreenAndBlockInputEnabled
◦
Rgsender.IsIloRemoteConsoleEnabled
◦
Rgsender.IsAnonymousConnectionForceEnabled
◦
Rgsender.PreferredDisplayMethods
◦
Rgsender.IsCollaborationNotificationEnabled
◦
Rgsender.IsReconnectOnConsoleDisconnectEnabled
●
Microphone properties group
◦
Rgsender.Mic.IsEnabled
●
Network timeout property group
◦
Rgsender.Network.Timeout.Error
◦
Rgsender.Network.Timeout.Dialog
●
USB access control list properties
◦
Rgsender.Usb.Acl.RulesetPath
◦
Rgsender.Usb.Acl.SchemaPath
◦
Rgsender.Usb.Acl.RulesetErrorTimeout
●
Network Interface binding properties
◦
Rgsender.Network.IsListenOnAllInterfacesEnabled
◦
Rgsender.Network.Interface.n.IsEnabled
◦
Rgsender.Network.AllowIpAddressSubnet
◦
Rgsender.Network.Port
●
Clipboard property group
◦
Rgsender.Clipboard.IsEnabled
Sender general properties
Rgsender.IsRdpLogoutDetectionEnabled=bool （1）
This property only applies to the Windows versions of the RGS Sender.
When a user disconnects from a RDC session, the Windows desktop on the Remote Computer is
immediately available for an RGS connection. However, if the user logs out of the RDC session, the
RGS Sender will be unable to access the desktop for about 60 seconds. If this property is set to 1, the
desktop will be available to RGS almost immediately. The RGS Sender will monitor the RDC session for
a logout, and begin the process of making the desktop available as soon as the logout is detected. If
RGS Sender properties
189