When rgadmin is started, it reports the current status of Single Sign-on and Easy Login. To change the
status, check the desired radio button. After clicking Apply, Single Sign-on or Easy Login are
immediately available on Windows Vista and Windows 7.
Figure 3-23 Dialog to enable or disable Single Sign-on and Easy Login (Windows Vista and
Windows 7)
Installing RGS on Linux
This section describes how to:
●
Install and uninstall the RGS Receiver on Linux
●
Audio requirements for the Linux Receiver
●
Install and uninstall the RGS Sender on Linux.
NOTE: The RGS Sender uses TCP/IP port 42966. The Linux installer adds an iptables entry to open
this port.
Installing the Receiver on Linux
NOTE: Beginning with RGS 5.1.3, the Linux RGS Receiver is available in both 32-bit and 64-bit
versions.
To install the RGS Receiver on Linux, perform the following steps:
1. Login as root.
2. Go to the directory where you downloaded RGS, and change to the directory lin32/receiver (32-
bit version) or lin64/receiver (64-bit version).
78 Chapter 3 Installing RGS
To Next Page
Loading...
