5
LEVELLING SAFETY MEASURES
• Park the vehicle on a surface that is as flat as possible.
• Check if the surface on which the jacks will rest is preferably flat, not slippery, and free of
debris, rocks, etc.
• When parking on a soft surface, plates or blocks must be used under the bases of the
jacks, to prevent the supports sinking into the ground.
• The handbrake must be engaged before the system can be operated. Without an
engaged handbrake, the system will not function.
• The gear must be set to neutral or park.
• Ensure that the system has enough voltage. if necessary, start the vehicle during leveling
if the voltage is insufficient.
• Maintain distance from the vehicle, slide-outs, awnings, doors, steps, etc. The vehicle can
move in all directions when deploying or retracting the jacks.
• In order to achieve the most accurate result possible, it is advised to operate the system
from outside the vehicle or otherwise avoid moving when inside the vehicle.
• Press the STOP button on the control panel at any time if the operation must be
interrupted.
• If the operation has been interrupted, all jacks must be retracted. After that, you can
start over.
• ALWAYS check if all jacks are resting properly on the ground.
• Disengage the vehicle's ignition when the system is ready.
• NEVER MOVE THE VEHICLE WHEN ONE OR MORE JACKS ARE DEPLOYED.
To Next Page
Loading...