10
HPC LASER LTD – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN WORKING
TROUBLESHOOTING
Problem: Engraver will not vector.
Solution:
Please verify that the print driver is set to “vector” or “combined”.
Verify that your artwork is correct for vectoring.
Scanned images will not vector.
Filled or solid images will not vector (outlines only).
If you are using CorelDraw verify that line width is .007 or less.
Problem: Engraving appears weak.
Solution:
All mirrors and lens need to be cleaned and inspected for damage,
please watch DVD for instructions.
Make sure that the lens is in correct focus.
Make sure the correct speed and power settings
for the type of material that you are engraving on.
Problem: No laser beam but the engraver appears to be running normally.
Solution:
Make sure focus is set properly
Make sure the power and speed settings are appropriate
Please refer to setting sheet provided with your machine
To Next Page
Loading...