6
HPC LASER LTD – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN WORKING
Section 2: Laser tube / pump
Unpack the water pump (if not using chiller) immerse in contained (min 35l of deionised
water), connect outlet from pump to water inlet pipe.
The return pipe goes back into the tank.
Remove air compressor from the box, connect the pipe which leads to the air inlet on the
rear of the engraver.
Connect all power leads into on 4-way extension.
Section 3: Fan Unit
Unpack the off centre fan unit, connect the horizontal inlet to the rear of the machine, and
vertical outlet to your exhaust. Plug in to extension lead.
Section 4: Installation of Software
Connect the USB lead to the computer, plug in the software dongle (looks like a small usb
stick) into the USB port, switch on the computer.
Insert software CD from the accessory pack.
Open CD drive on computer, click on English.
Double click on install
Double click on set-up
(welcome to use)
Click Set-up
(proceeding date)
Succeed in install)
Click “OK”
Close Box
The software will install on the desk top, with an icon stating “laser cut”.
Double click on this to open the software.
Section 5: Initial set up of engraver
Power on the extension lead, check the fan and air pump are working, check the water
flow through the laser tube, visually inspect to make sure there are no air bubbles, (if these
do not disappear release the clamps and rotate the tube gently to be in a position where
these are no longer visible) –re-tighten clamps on completion double check the engraver is
level.
Close the rear flap over the laser tube, lock and remove keys (put away for safe keeping)
To Next Page
Loading...