7
HPC LASER LTD – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN WORKING
On the rear of the machine, switch the on / off switch to “on”
If the red emergency button on the top of the machine is “depressed” turn clockwise to
release this.
(The machine MUST run for a minimum of 5 minutes to ensure the tube is at a
constant temperature – before each use).
Now turn the key switch to the “on” position, check the alignment (as per DVD) ensure the
Lid is down, and all side doors are closed and locked before firing the laser.
To check alignment:-
Tear four pieces (each 15cm) Cardboard and stick onto each lens (try your best to
not stick onto the lens, as picture 1). Manual test “laser”, laser will print one black
point on the paper. Do not hold the “laser” switch down, just enough to make a
black point appear. The position of black point should be in the middle of reflection
lens (as picture 2).
Follow the above instructions for lens 1 and 2
To Next Page
Loading...