8
HPC LASER LTD – NEVER LEAVE YOUR MACHINE UNATTENDED WHEN WORKING
After adjusting lens 1 and lens 2, stick the adhesive paper onto the dolly, and then
move the dolly to the top of the bed, close reflection lens 3 and reflection lens 4,
manual test the laser and print one black point. Then move the dolly to the most
right hand side, manual test the laser and print one black point. The black dot needs
to be central in the cardboard, if not, adjust manual screw of lens 4, and then test,
until finally completely central.
YOUR MACHINE IS NOW READY TO USE
Note: if machine is re-sited, the above procedure
needs to be repeated
If your machine was installed by an HPC LASER ENGINEER please refer from this
section:-
To Next Page
Loading...