5
PUNCH MACHINE
™
Preparation
Attach Punch Handle to The Punch Machine
™
Should you need to package The Punch Machine
™
for transport or shipping, you’ll need to remove the
Punch Handle Assembly. Simply reverse the above
procedure to remove the Punch Handle Assembly.
1. Insert handle into open hole of handle axle,
flush to opposite side.
2. Turn handle to straight up position.
3. Using a 1/8"Allen Wrench, insert
the provided 1/4"- 20 x 3/8" Dog Point
Allen Screw into hole located below
the handle and tighten. Lower handle.
Never lift the Punch Machine
™
by the
Handle! Always lift the Punch Machine
™
from the bottom using both hands.
IMPORTANT NOTE!
No. 1200PCH
To Next Page
