72
PUNCH MACHINE
™
Preventive Maintenance, Lubrication,
Repairs, and Warranty
2. BEARINGS AND SLIDING SURFACES — These are to be given a light coat of a light grease at
least every six months.
3. EXPOSED STEEL SURFACES — All remaining exposed steel shafts, cutters, etc., should be sprayed
with WD-40 or equivalent light oil at least every six months. Wipe off any excess.
4. CLEANING — Remove all brass chips, dirt, and grit from the surface of your machine daily, with a
soft bristle brush. Take particular care in keeping the jaw area clean and free of all residue build-up.
5. CODE CARDS — The Code Cards are made of durable card stock and die cut to extremely close
tolerances. Dirt is easily washed off with a mild, non-abrasive liquid detergent, such as dishwashing
soap and lukewarm water. Dab lightly with a soft cloth until dry. Never use an abrasive or solvent-
based cleaner to wash these Code Cards!
6. REPAIRS — The preventive maintenance and recalibration of space and depth, as fully outlined
on previous pages are the ONLY
REPAIRS or ADJUSTMENTS suggested.
Internal operating mechanisms are FACTORY
REPAIRABLE ONLY. Do not incur additional
repair charges by attempting to fix the machine
yourself.
1. WARRANTY — The Punch Machine
™
is fully warranted for one year from the date of
purchase,
against factory defects in material and workmanship. Mail the Warranty Card and a copy of your invoice
immediately to validate your warranty. Should your machine require factory repairs, please contact
During the one year warranty period, you will be billed for handling and shipping only.
HPC SERVICE DEPARTMENT: 1-800-323-3295
No. 1200PCH
the HPC Service Department.
To Next Page
Loading...
