4
HOW TO USE
1. SWITCHING ON / OFF HEADSET
Function Operation LED Indicator Voice Prompt
Switch on Press the MFB button for 3
seconds, and release it till
the blue LED is on
Blue LED blinks 3 times. Power On
Switch off Press the MFB button for 5
seconds, and release it till
the red LED is on
Red LED blinks 3 times Power Off
2. PAIRING THE HEADSET WITH BLUETOOTH DEVICES
A. How to enter pairing mode
Function Operation LED Indicator Voice Prompt
Enter pairing mode Make sure the headset is
off. Press and hold MFB
button for 6 seconds, and
release it until the red and
blue LEDS blink alternately
Red and blue LEDs blink
alternatively.
Pairing
B. Pairing the headset with a Bluetooth mobile phone
Please make sure your mobile phone has a Bluetooth function that can be used.
Note: Specic pairing procedures may vary with different mobile devices.
Please refer to your mobile device manual for further information. Steps as
follows:
• Please keep the headset and mobile phone in the range of 1 meter when pairing.
• Make the headset enter into pairing mode (LED is blinking red and blue)
• Start the Bluetooth function of the mobile device and search for new Bluetooth devices.
Select “8018807-20” in the Bluetooth device list.
• When you are prompted, enter password or PIN No: “0000”, and press the “Yes” key or
“conrmed”. ( depending on the Bluetooth device’ settings )
• After successful pairing, select “8018807-20” in the Bluetooth device list, and press
“connect”.
• After pairing is successfully completed, the blue LED of the headset will keep blinking.
Notes:
• If the pairing is not successful, switch off the headset, and then pair again.
• After pairing is successful, paired devices will remember each other. Unless pairing
information is deleted because of new pairing, it will not be necessary to pair again the
next time you use the device. If you want to pair the headset with other devices, please
pair it with the new device according to steps 1~6 mentioned above.
• Multilink technology allows simultaneous connection to two different devices. Simply
repeat the pairing process on both devices.
• If a driver is not found, a Windows update may be necessary. Please visit the Microsoft
website to obtain your update.
3. RE-CONNECTING TO A BLUETOOTH DEVICE
To Next Page
Loading...