Step 5: Install stand-off insulators on the top panel of the cabinet, and fix the output
busbars firmly to the stand-off insulators top by bolts.
Step 6: Connect securely positive terminal of each module with the bottom end of
positive output cables . Direct the positive cable up, towards the cabinet’s top panel,
along the side panel as shown on the picture (below-left), through one of two cable
holes in the top panel of the cabinet. Then connect the top end of the positive output
cable firmly, by bolt, to the positive busbar installed on stand-off insulators on the
cabinet top panel, as its shown on the picture (below-right).
To Next Page
Loading...
Need help?
General
