Fitting the cuff
Note
1).Put the cuff on a table flatly with the velcro side
down.Pass the end of the cuff through the metal loop
so that a circle is formed.The velcro closer will now
be facing outwards(ignore this step if the cuff has
already been prepared).
2).Push the cuff over the left upper arm so that the
tube points in the direction of the lower arm.
3).Wrap the cuff on the arm as illustrated.
Make certain that the lower edge of the cuff lies
approximately 2 to 3 cm above the elbow and the
rubber tube leaves the cuff on the inner side of the arm.
4).Tighten the free end of the cuff and close the cuff
by affixing the velcro.
5).The cuff should be snug on your upper arm so
That you can fit 2 fingers between the cuff and your
upper arm. Any piece of clothing restricts the arm
which must be taken off.
6).Secure the cuff with the velcro closer in such a way
that it lies comfortably and not too tight. Lay your arm
on a table(palm upwards)so that the cuff is at the same
height as the heart.Do not bend the tube.
If it is not possible to fit the cuff to your left arm,it can
also be placed on the right.However,all measurements
should be made using the same arm.
：
Proper use of the unit
13/25
2-3cm
To Next Page
Loading...