B Spare parts
HSD S.p.A. © - h0111k01a.fm120718
193
B Spare parts
The parts that can be replaced are listed below.
To replace the parts marked with an asterisk, contact the manufacturer's Service
Centre. No responsibility will be accepted if the user fails to observe this indication.
SPARE SHAFT KIT
Spare shaft kits are available for installation if the bearings are excessively worn.
To obtain the correct shaft kit for the model in question, inform the HSD sales office of the
spindle serial number.
The serial number is usually stamped on the front flange or on the front of the casing (see
paragraph
3.4 “General overview and main parts”).
For versions with a rotary fluid distributor and/or synchronous motor, the user cannot
replace the shaft kit; refer to appendix
D “Customer service”.
For the OR rings used when replacing the shaft kit, refer to paragraph
9.1 “Replacing the
shaft kit”
.
Manufacturer code Description
H2161H0022
Coolant ARTIC-FLU-5 (5-litre tank)
H41805006 Sensor S1
H5664H0060 Sensor S1 (versions with S5 only)
H4180500601 Sensor S2
H4180500602 Sensor S3
H5664H0016 Sensor S4
H5664H0017 Sensor S5
H6200H0052 HSD movable mounting plate
2138A0607 Movable military power connector (6-pin)
2138A1004 Movable military power connector (9-pin)
2138A0604 Movable military signal connector
2138A0229 Encoder female connector
2147A0404 Straight encoder connector
2147A0137 Curved encoder connector
H1401H0010 Rubber cover for protecting the inside of the spindle
H1707H0030 ISO30 cone for protecting the interior of the spindle
H1707H0031 HSK F63 cone for protecting the interior of the spindle
H3811H1547 HSK A40 gauge for “S1 doesn't read” adjustment
To Next Page
Loading...
