To Next Page

To Previous Page

14 SECURIO B 22 12/2014

english

6 Troubleshooting

Display Problem Measure

Continu-

ous lamp

Paper

jam

You have fed in too much paper.

 The cutting unit runs in reverse for a few seconds and pushes the

paper back out again.

• If necessary, press the reverse button “R” to remove the stack of paper.

• Take half the stack of paper.

• Feed the paper in portions.

Overload • The motor was overloaded. Let the shredder cool down for approx.

15 – 20 mins. before using it again.

Flashing

light

General

fault

displays

• A fault has occurred while shedding paper.

Pull the paper out of the slot to clear the light barrier.

Shredded

material

container

full

• Empty the shredded material container.

Note:

If you press the reverse button brieﬂ y before removing the container,

part of the material is pulled back into the cutting apparatus.

Container

open

• Insert the shredded material container correctly in the base cabinet.

https://www.supplychimp.com/

Questions and Answers:

Need help?

Do you have a question about the HSM SECURIO B22c and is the answer not in the manual?

HSM SECURIO B22c Specifications

General