HT Simple Touch - User Manual

To Next Page

15-Channel Remote Programing Instruction

Press Up button to move shade to top limited location.

Press Up and My Favorite buttons at the same time for 5 seconds.

You will hear 3 short "B".

Top limit setup completed.

Press Down button to move shade to bottom limited location.

Press Down

and My Favorite buttons at the same time for 5 seconds.

You will hear 3 short "B".

Bottom limit setup completed.

Press My Favorite button for 5 seconds. Wait for a short "B".

Then press My Favorite

button again for 3 seconds. Wait for 3 short "B".

My Favorite position setup completed.

* Hide unused channels on remote

Press and hold Left and Right buttons at the same time, and then "C" will show on the screen. Wait

until "15" shown on the screen, then release buttons.

Press Left or Right button to select how many channels you want to show on the screen. For

example, if you only have 10 motorized shades connected to this remote, please select "10".

Press and hold My Favorite button (a small "0" will appear first) until channel number shown on

the screen again.

Setting completed.

* Reset/ Re-programing

Press Up, My Favorite, and Down buttons at the same time. Don't release until you hear a long "B".

Start programing

from Step 1 to Step 4 above.

Use Left or Right button to select channel from

1 to 15.

Press motor receiver with pin or paper clip for

2 seconds. Wait for motor to "jog".

Click P2 button (on back of remote) with pin

or paper clip, and then wait for motor to "jog".

Click P2 again and wait for another "jog".

Click Up button.

RF connection completed.

Step 1. 15-Channel Remote Frequency Connection

Setp 2. Setup Top Limit

Setp 3. Setup Bottom Limit

Step 4. Setup My Favorite Position

Back side of remote

* Unhide channels on remote

Press and hold Left and Right buttons at the same time, and then "C" will show on the screen.

Wait until "15"shown on the screen, then release buttons.

Press My Favorite button (a small "0" will appear on screen).

Setting completed.

Operate the shade to your favorite position.

February 2019

Simple Touch 15-Channel Remote

Need help?

Do you have a question about the HT Simple Touch and is the answer not in the manual?

Summary

15-Channel Remote Frequency Connection

Setup Top Limit

Setup Bottom Limit

Setup My Favorite Position

Hide Unused Channels

Unhide Channels

Reset;Re-programing

Shade Operation

Extend and Retract Shade (Before Favorite Setup)

Instructions for extending and retracting the shade prior to setting a favorite position.

Extend and Retract Shade (After Favorite Setup)

Instructions for extending and retracting the shade after a favorite position has been set.

Operate to Favorite Position

How to operate the shade to its pre-set favorite position.

Remote Control Management

Add Duplicated Remote

Steps to add a new remote control to an existing setup.

Disconnect Duplicated Remote

Procedure to remove a previously paired remote control.

Remove All Connected Remotes

Process to disconnect all paired remote controls from the shade.

Trouble Shooting

Remote Not Working

Check batteries and cord connectors for remote functionality issues.

One-Direction Control

Troubleshoot issues where the remote only controls the shade in one direction.

Connection Failure

Steps to resolve when the remote is unable to connect to the shade.