Get Started 4
Replace the battery compartment cover.
2. Charge your battery.
Plug one end of the USB cable to the AC adapter.
Plug the other end of the USB cable into the charger/accessory jack on the lower left
side of your device.
Plug the AC adapter into an electrical outlet. Fully charging a battery may take up to
three hours.
Note: Your device’s battery should have enough charge for the device to turn on and find a
signal, run the setup application, set up voicemail, and make a call. You should fully
charge the battery as soon as possible.
3. Press to turn the device on.
If your device is activated, it will turn on, search for Sprint service, and begin the
setup application.
If your device is not yet activated, see Activate Your Device for more information.
To Next Page
Loading...
