HTC GL 25 D - Lowering the Dust Extractor to the Transport Position

Operation HTC GL 25 D
14 1.1
Figure 4-3. Operating position
Warning!
If the catches are not properly located in the lugs, there is a risk that the dust
cylinder package can drop, with a consequential risk of crush injury.
4.2.2 Lowering the dust extractor to the transport position
The dust extractor can be lowered to the transport position, see Figure4-4, page15.
When the dust extractor is in the operating position, and you want to lower it to the
transport position, do as follows:
1. Lift the dust cylinder package with both hands, using the lifting handles, see
Figure3-1, page8. To avoid the risk of the suction system tipping, place a foot
on the collection plate for the waste bag.
2. Lift the dust cylinder package up and out a little, so the catches, see Figure4-2,
page13, release. Then let the dust cylinder package drop slightly and fold in the
dust cylinder package again, so the catches fasten in the lower lug on the chassis for
transport position.