HTC GL 450 - Fitting and Replacing Grinding Tools

HTC GL
270/400/450/550 Usage
1.0 15
Warning!
Always ensure that the machine's handle is in the upright position when the
machine is tipped to enable access beneath the grinding head. Otherwise, there
is a risk that the machine could fall back and cause personal injury.
• Adjust and lock the handle in the desired position, using the locking mechanism,
seeFigure 3-2, page 11.
• Adjust the handle to the desired angle to achieve the best ergonomics, see
Figure 3-2, page 11.
4.3 Access to grinding tools
Warning!
During grinding, the tools become very hot. Tip the machine back and allow it
to stand for a short while. Use protective gloves when removing the tools.
Warning!
Disconnect the electrical supply, when changing tools or repairing the machine.
1. Set the handle to the upright position - see Figure 4-1, page 14
2. Tip the machine backwards so that it rests on the ground.
4.4 Fitting and replacing grinding tools
Warning!
Disconnect the electrical supply, when changing tools or repairing the machine.
Warning!
During grinding, the tools become very hot. Tip the machine back and allow it
to stand for a short while. Use protective gloves when removing the tools.
Note!
Check that the motor's direction of rotation agrees with the direction arrow on
the motor. This is to guarantee the correct use of the T-Rex A grinding tool.