HTC Outfeed Rollers HOR-1038U - Model-Specific Installation Notes; Delta Unisaw Owners Advisory; Lowering the Delta Unisaw LVC Box

LVC Box
Tag and label
wires for removal
Relocated LVC box with main frame
Attention Delta Unisaw Owners
 IfyourtablesawisaDeltaUnisaw,withanLVC(LowVoltageController)
boxmountedontherearofthetablesawcabinet,pleasereadandfollowthe
instructionsinthissectioncarefullybeforeproceedingwithinstallationofthe
HTC OutfeedRollerSystem.Otherwiseskiptonextpage.
 TheLVCboxmayneedtobelowered3"toprovideenoughspaceforthe
topmountingchanneloftheOutfeedRollerMainFrame.Readthroughthe
entireinstallationinstructionspriortomovingyourLVCbox.Thefollowing
instructionswillguideyoustepbystepthroughthesimpleprocedureof
loweringtheLVCbox,ifnecessary.
Tools needed to lower the Delta Unisaw LVC Box
 Safetygoggles
 Handdrillwith1/8"and11/32"drillbits
 Scribe,awlormarkingdevice
 Fileordeburringtooltoremovesharpedgefromholes
Center punch
 Ballpeenhammer
 1-1/2"diameterholesaw(availableatanyhardwarestore)
 Two(2)1/2"wrenches
Lowering the Delta Unisaw LVC Box
WARNING: Toavoidelectrocutiondisconnectpowerfromthetable
sawbeforeproceeding.
1. RemovethecoveroftheLVCbox.Taganddisconnectthesix (6)wires
fromtheterminals.
2. Removelocknutsfromthetwo(2)wireclampsandpullthewiresthrough
thebackoftheLVCbox.
3. DisconnectLVCboxbyremovingthree(3)5/16"boltsandnuts.
4. Locatetoptwo(2)existingmountingholes.Relocatethesesameholes
3"lowerthanoldholes.Markwithcenterpunch.Drill1/8"pilotholesto
reducewanderinsheetmetal.Drillthetwonew11/32"holes.Remove
sharpedgeonholes.
5. TemporarilyremountLVCboxwiththetwo(2)topmountingboltsinthe
new3"lowerholes.Tracetheoutlineofthelowermountingholeandthe
two(2)wireaccessholes.
6. RemovetheLVCboxagain.Markandcenterpunchthethree(3)holes
tracedinStep5.
7. Drillthree(3)1/8"pilotholes.Drill11/32"lowermountinghole.Drilltwo
(2)wireaccessholeswith1-1/2"diameterholesaw.Removesharpedge
onholes.
8. RemounttheLVCbox,rewiremakingsuretomatchtaggedwiresfrom
Step1andreplacecover.
4
LVC box may need to be lowered 3"
3"