HTC Outfeed Rollers HOR-1038U - Installation Instructions; Tools Needed for Assembly

8
Installation Instructions
Tools needed for Assembly
 Safetygoggles
 Scribe,awlormarkingdeviceformarkingonsheetmetal
Center punch
 Ballpeenhammer
 Fileordeburringtooltoremovesharpedgefromholes
 Combinationsquare
 Framingsquareorlongstraightedge
 Handdrillwith1/8"and11/32"drillbits
 1/2"deepsocketwrench
 1/2"openendwrench
 7/16"socketwrenchand/oropenendwrench
Note:ReadthroughALLinstallationinstructionsandreviewalldiagrams
beforeattemptinginstallation.
WARNING: Toavoidelectrocutiondisconnectpowerfromthetable
sawbeforeproceeding.
Figure 1