HTC Outfeed Rollers HOR-1038U - Operating Instructions; Cam Action Operation; Storage and Folding; Care and Maintenance

Outfeed Roller Feature
and Operating Instructions
Cam Action
Theuniquecam-actionoftheHTCOutfeedRollersallowtherollersurface
tobequicklyandeasilylowered3/8"tosupportthemitergaugebar.This
allowstheuseofmiterorcross-cutboxesoranyotherslidingmiterfixtures
orjigs.Thecam-actionassuresthattherollersremainparalleltothetable
sawandthatthefullyadjustableheightmechanismremainsinprecise
alignmentwiththetablesawsurfaceandmitergaugeslot.
Figure12showsthecam-actioninthedownpositionwiththerollersinthe
uppositionforsupportingtheworkpieceinanormalcuttingmode.
Figure13showsthecam-actionintheuppositionwiththerollersinthe
downpositiontosupportthemitergaugeguidebarforjigorfixturemode.
Storage
How to Fold Outfeed Rollers
TherecommendedprocedureforfoldingtheOutfeedRollersistoreleasethe
lockingmechanismwithyourfootwhileholdingtherollersectionfirmlywith
twohands.(SeeFigure14)Makesuretherearenoworkpiecesoranything
elseontheOutfeedRollerswhenfoldingtothedownposition.Afterthe
lockingmechanismisreleased,gentlyfoldtheOutfeedRollersdownasin
Figure15.
WARNING: Keephandsandbodypartsawayfrompinchpoints
whenfoldingOutfeedRollerstodownposition.
Care and Maintenance
WhiletheHTCOutfeedRollerisdesignedandbuilttowithstandtheeveryday
activitiesofvirtuallyanyworkshopenvironment,afewcommonsensecare
andmaintenanceprocedurescanhelpincreasethelifeandenjoymentof
yournewpurchase.Keepingthreadedandhingedpartsfreefromdust
buildupwillkeepthosepartsmovingasfreelyastheyareintended.Dust
buildupshouldalsobeavoidedontheaxlesoftheballbearingrollers
byregularcleaning.Alightlubrication(whenneeded)oftherolleraxles
andOutfeedRollerhingeinthesupportarmactionisalsosuggestedfor
consistent,easyoperation.Adampragisrecommendedforcleaningthe
frameandsupportarmofyourOutfeedRoller.
NOTE:DO NOThoseyourOutfeedRollerdownwithwatertocleanit.
11
Workpiece
Guide Bar
3
/8''
Saw
Cross Cuts
Down Position
Figure 13
Workpiece
Saw
Rip Cuts
Up Position
Figure 12
Figure 14
Figure 15