§ Make sure your finger and the fingerprint scanner are dry and clean.
§ Use the entire pad of your finger, including the sides and tip.
§ When recording your fingerprint, touch the scanner until it vibrates.
§ The fingerprint scanner has 360° readability—you can touch a recorded finger at any angle to
the scanner to turn on the screen or unlock the HTC U12 life.
You may not be able to set the fingerprint scanner to unlock HTC U12 life, if you've signed in to
an Exchange ActiveSync
®
account that requires you to set a different screen lock option (such as
password). Check with your Exchange Server administrator if your Exchange ActiveSync
account supports the fingerprint scanner.
Adding a fingerprint the first time
1. From the Home screen, swipe up and then tap Settings Security & location.
2. Tap Fingerprint Next.
If you haven't already set up a screen lock, you'll be asked to set one up. See
Setting a screen lock on page 92.
3. Touch the Fingerprint scanner or tap Next.
4. Place your finger or thumb on the Fingerprint scanner to start scanning.
5. Repeatedly touch the scanner until the fingerprint has been successfully recorded. You'll get
the best results if you hold your finger in the same direction when touching the scanner.
6. After you've successfully recorded your fingerprint, tap Done.
You can now use your fingerprint to wake up and unlock your HTC U12 life.
You'll need to input your backup lock screen pattern, PIN, or password if the scanner doesn't
identify your fingerprint after five attempts.
Adding, removing, or editing fingerprints
1. From the Home screen, swipe up and then tap Settings Security & location.
2. Tap Fingerprint.
3. Enter your pattern, PIN, or password.
4. Do any of the following:
§ Tap Add fingerprint to add another fingerprint.
§ Tap a recorded fingerprint to rename it.
§ Tap next to a recorded fingerprint to delete it.
18 Unboxing and setup
To Next Page
Loading...
