HTC Vive Tracker - Accessory Design

Vive Tracker
Developer Guidelines
HTC Corporation 07/17/2017
V
er.
1.5
16
HTC Confidential and Proprietary
Accessory design
Below are the different accessory mechanisms, following ISO standards:
 1/4” bolt design
Please refer to ISO 1222-2010, Figure 1 on page 1.
 Stabilizing pin design
Vive Tracker leverages the design from ISO 1222-2010, Figure 5 on page 3. For details
on dimensions and tolerances, please refer to pages 13-17. It is suggested to apply the
Stabilizing Pin for better tracking performance.
 Screw thread design
The screw thread type that applies to Vive Tracker is 1/4” screw with 1.27 mm pitch. For
detailed information, please refer to ISO 1222-2010, pages 3-5.