23
HTP 15 Series MIG Welding Gun
The smallest of the guns. Excellent for reaching into tight spaces (e.g., work on cars). Also, lightweight for less
operator fatigue. Best for use on steel (non-pulse). Not suitable for pulse welding steel, and limited potential for pulse
welding silicon bronze in the collision repair industry. Although we also sell the gun in 12’ and 15’ lengths, only the
10’ gun may be used when welding .023” diameter wire, and even larger diameter wires will most likely NOT give
you a trouble-free welding experience. We, therefore, recommend using only a maximum gun length of 10’. If you
require a longer gun, either upgrade to a push/pull system or to the Pro Pulse 300, which features a different wire feed
system.
Part# Description Part# Description
A. 15023-10 .023” Contact Tip, 10-Pack I. 13002-DLT Gas Diffuser
A. 15030-10 .030” Contact Tip, 10-Pack J. 14009 Trigger Switch
A. 15035-10 .035” Contact Tip, 10-Pack L. 15100 10’ MIG Gun
C. 15106 Spot Weld Nozzle L. 15120 12’ MIG Gun
D. 15104 Cylindrical Nozzle L. 15150 15’ MIG Gun
E. 15105B Conical Nozzle, 3-Pack M. 15040-16 16’ Steel Liner
F. 15108 Small Conical Nozzle N. 50013 Consumable Kit
G. 15058 Head Insulator f/Flex Neck O. 63160 Drive Roll f/Steel, .023”-.030”
G. 15500 Flexible Swan Neck P. 63498 Drive Roll f/Flux-Cored Wire
H. 15062B Nozzle Retaining Spring, 4-Pack Q. 15510 10’ Flex Neck MIG Gun
I. 14058 Head Insulator Q. 15512 12’ Flex Neck MIG Gun
I. 15002 Swan Neck, Standard Rigid Neck Q. 15515 15’ Flex Neck MIG Gun
To Next Page
Loading...
Need help?
General
