To Next Page

To Previous Page

HTP 24 Series MIG Welding Gun

Slightly larger than the 15 Series MIG Welding Gun. Still lightweight and fits into most small spaces. For pulse

welding, we recommend a maximum gun length of 10’. Although we also sell the gun in 12’ and 15’ lengths, only the

10’ gun may be used when welding .023” diameter wire, and even larger diameter wires will most likely NOT give

you a trouble-free welding experience. We, therefore, recommend using only a maximum gun length of 10’ . If you

require a longer gun, either upgrade to a push/pull system or to the Pro Pulse 300, which features a different wire feed

system. For any kind of pulse welding, long-life tips should be used. Failure to do so will result in premature tip wear,

poor weld quality, burn backs, birds nesting, and other problems. The 24 Series MIG Welding Gun can be used for:

 Steel (all diameters and thicknesses; both pulse and non-pulse)

 Flux-cored (all thicknesses; with or without gas)

 Stainless Steel and Silicon Bronze (all thicknesses)

Part# Description Part# Description

24023-10 .023” Contact Tip, 10-Pack 24105B Conical Nozzle, 3-Pack A. E.

24030-10 .030” Contact Tip, 10-Parck 24108B Small Conical Nozzle, 3-Pack A. F.

24035-10 .035” Contact Tip, 10-Pack 24002-DIF Gas Diffuser A. G.

24045-10 .045” Contact Tip, 10-Pack 24002-TH Tip Holder A. H.

24030-10CR .030” Long-Life Contact Tip 24002 Swan Neck A. I.

24035-10CR .035” Long-Life Contact Tip 24100 10’ MIG Gun A. J.

24040-10CR .040” Long Life Contact Tip 24120 12’ MIG Gun A. J.

A. 24045-10CR .045” Long Life Contact Tip K. 15040-16 16’ Steel Liner

C. 24106B Spot Weld Nozzle, 3-Pack L. 63160 Drive Roll f/Steel, .023”-.030”

D. 24104B Cylindrical Nozzle, 3-Pack K. 634980 Drive Roll f/Flux-Cored Wire

Questions and Answers:

Need help?

Do you have a question about the HTP Pro Pulse 220 MTS and is the answer not in the manual?

HTP Pro Pulse 220 MTS Specifications

General