To Next Page

To Previous Page

HTP 26 Series MIG Welding Gun

Noticeably larger than the 24 Series MIG Welding Gun with a thicker torch cable (the thicker torch cable helps the

operator keep the gun straight, which is especially important when welding aluminum). Comes in an 8’ length with

M8 size long-life tips. The 26 Series MIG Welding Gun can be used for:

 Aluminum (EVERY wire diameter from .030” to .047” (3/64”); EVERY alloy (4043, 5356, and 5554 namely))

The 26 Series MIG welding gun might also be used for:

 Steel (all diameters and thicknesses; both pulse and non-pulse)

 Flux-cored (all thicknesses; with and without gas)

 Stainless Steel and Silicon Bronze (all thicknesses)

In doing so, modifications to the gun must be made (a different liner must be installed), which essentially renders the

gun useless for aluminum. However, a modification like this may be a good choice if you require an extra heavy-duty

welding gun for high heat situations and the 24 Series MIG welding gun does not provide sufficient performance.

Part# Description Part# Description

A. 26030-10CR .030” CRZR Contact Tip, 10-Pack E. 26002-THM8L Tip Holder, Long

A. 26035-10CR .035” CRZR Contact Tip, 10-Pack F. 26002-DIF Gas Diffuser

A. 26045-10CR .045” CRZR Contact Tip, 10-Pack G. N/A Swan Neck

B. 26104-3 Cylindrical Nozzle, 3-Pack H. 26080 8’ MIG Gun

C. 26105-3 Conical Nozzle, 3-Pack I. 63464 Drive Roll f/Aluminum

D. 26108-3 Small Conical Nozzle, 3-Pack J. 26040-11 11’ Graphite Liner

E. 26002-THM8S Tip Holder, Short K. 50026 Consumable Kit

Questions and Answers:

Need help?

Do you have a question about the HTP Pro Pulse 220 MTS and is the answer not in the manual?

HTP Pro Pulse 220 MTS Specifications

General