4
3. Remove the liner from the double-sided adhesive tape
on the back of the bracket.
4. Attach the bracket to the area you have cleaned, and
press the bracket from top to bottom hard and evenly
with at least 15 PSI (1 kg/cm
2
) of pressure for 30
seconds or longer. Check the bubbles from the other
side of the glass, and make sure that the bracket is
fully attached to the glass. Do not remove or touch the
adhesive, as doing so may impair the adhesive force.
If there are a lot of bubbles on the double-sided
adhesive tape, remove and then re-install the bracket.
To Next Page
Loading...
Need help?
General
