Huawei AR1200 Series - Page 130

Table 5-93 Buttons and indicators on the 1PON panel
Number
in Figure
5-28
Indicator Color Description
1 STAT Green If the indicator blinks once 2s (0.5 Hz),
the system is running properly.
If the indicator blinks once 0.25s (4 Hz),
the system is powering on or restarting.
Red If the indicator is red, a fault that affects
services occurs and cannot be rectified
automatically. The fault needs to be
rectified manually.
Off If the indicator is off, the software is not
running or is being reset.
2 and 3 PON interface
indicators:
l The LINK
indicator indicates
whether the PON
card is requesting
data transmission.
l The AUTH
indicator indicates
the authentication
status.
Green
If both the LINK indicator and AUTH
indicator are steady on, the 1PON card is
registered successfully.
If the LINK indicator is steady on and the
AUTH indicator blinks once 0.25s (4
Hz), the 1PON card is being registered.
If both the LINK indicator and AUTH
indicator blink once 0.25s (4 Hz), the
1PON card keeps requesting data
transmission. When this occurs, the
1PON card is a rogue ONU.
If both the LINK indicator and AUTH
indicator are off, the 1PON card does not
request data transmission.
Interfaces
Table 5-94 describes the types and functions of interfaces on the 1PON card.
Table 5-94 Types and functions of interfaces on the 1PON card
Letter in
Figure 5-28
Name Qua
ntity
Description Cable Type
a PON
interface
2 The 1PON card provides
EPON/GPON interfaces
that are connected using
SC/PC fibers.
6.6 Optical Fiber
Huawei AR1200&2200&3200 Series Enterprise Routers
Hardware Description 5 Cards
Issue 03 (2012-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
123