Huawei AR1200 Series - Page 32

Procedure
l Perform the following steps to configure a link Hello send timer:
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The view of an interface on which an LDP session is to be established is displayed.
3. Run:
mpls ldp timer hello-send interval
A link Hello send timer is configured.
The default value of a link Hello send timer is one third of the value of a link Hello
hold timer.
Effective value of a link Hello send timer = Min { Configured value of the link Hello
send timer, one third of the value of the link Hello hold timer }
l Perform the following procedure to configure a link Hello hold timer:
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The view of an interface on which an LDP session is to be established is displayed.
3. Run:
mpls ldp timer hello-hold interval
A link Hello hold timer is configured.
The default value of a link Hello hold timer is 15, in seconds.
A smaller value between two configured link Hello hold timers on both ends of the
LDP session takes effect.
l Configure a KeepAlive send timer.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The view of an interface on which an LDP session is to be established is displayed.
3. Run:
mpls ldp timer keepalive-send interval
A KeepAlive send timer is configured.
The default value of a KeepAlive send timer is one third of the value of the KeepAlive
hold timer.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS 2 MPLS LDP Configuration
Issue 01 (2011-12-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25