Huawei AR1200 Series - Configuring the VTY User Interface

To Next Page

To Previous Page

Context

Perform the following steps on the interfaces of both ends of the link between the crossing node

of active and standby links and the LDP neighboring node on the active link:

Procedure

Step 1 Run:

system-view

The system view is displayed.

Step 2 Run:

interface interface-type interface-number

The interface view is displayed.

Step 3 Run:

mpls ldp timer igp-sync-delay value

The period of waiting for the LSP setup after the establishment of the LDP session is set.

By default, the value of the delay timer is 10 seconds.

----End

2.7.6 Checking the Configuration

After the configuration of LDP and IGP synchronization, you can view the synchronization and

route management information on interfaces enabled with LDP and IGP synchronization.

Prerequisite

The configurations of the synchronization between LDP and IGP function are complete.

Procedure

l Run the display ospf ldp-sync interface { all | interface-type interface-number } command

to check information about synchronization between LDP and OSPF on the interface.

l Run the display isis [ process-id | vpn-instance vpn-instance-name ] ldp-sync interface

command to check information about synchronization between LDP and IS-IS on the

interface.

l Run the display rm interface [ interface-type interface-number | vpn-instance vpn-

instance-name ] command to check information about the route management.

----End

Example

l If the configurations succeed, run the display ospf ldp-sync or display isis ldp-sync

command. The status of the interface configured with synchronization between LDP and

IGP is Sync-Achieved.

l Run the display rm interface command. You can see that the LDP-IS-IS or LDP-OSPF

synchronization is enabled.

Huawei AR1200 Series Enterprise Routers

Configuration Guide - MPLS 2 MPLS LDP Configuration

Issue 01 (2011-12-30) Huawei Proprietary and Confidential

Other manuals for Huawei AR1200 Series