Huawei AR1200 Series - Configuring a Remote LDP Session; Establishing the Configuration Task

PeerID Status LAM SsnRole SsnAge KASent/Rcv
------------------------------------------------------------------------------
2.2.2.2:0 Operational DU Passive 0000:01:36 387/386
3.3.3.3:0 Operational DU Passive 0000:01:30 361/361
------------------------------------------------------------------------------
TOTAL: 2 session(s) Found.
<Huawei> display mpls ldp session verbose
LDP Session(s) in Public Network
------------------------------------------------------------------------------
Peer LDP ID : 2.2.2.2:0 Local LDP ID : 1.1.1.1:0
TCP Connection : 1.1.1.1 <- 2.2.2.2
Session State : Operational Session Role : Passive
Session FT Flag : Off MD5 Flag : Off
Reconnect Timer : --- Recovery Timer : ---
Keychain Name : kc1
Negotiated Keepalive Hold Timer : 45 Sec
Configured Keepalive Send Timer : 3 Sec
Keepalive Message Sent/Rcvd : 438/438 (Message Count)
Label Advertisement Mode : Downstream Unsolicited
Label Resource Status(Peer/Local) : Available/Available
Session Age : 0000:01:49 (DDDD:HH:MM)
Session Deletion Status : No
Capability:
Capability-Announcement : On
Outbound&Inbound Policies Applied :
outbound peer 2.2.2.2 fec none
outbound peer all split-horizon
inbound peer 2.2.2.2 fec none
Addresses received from peer: (Count: 3)
10.1.1.2 2.2.2.2 10.1.2.1
------------------------------------------------------------------------------
Run the display mpls ldp peer command to view LDP peer information.
<Huawei> display mpls ldp peer
LDP Peer Information in Public network
A '*' before a peer means the peer is being deleted.
------------------------------------------------------------------------------
PeerID TransportAddress DiscoverySource
------------------------------------------------------------------------------
2.2.2.2:0 2.2.2.2 GigabitEthernet1/0/0
3.3.3.3:0 3.3.3.3 GigabitEthernet2/0/0
------------------------------------------------------------------------------
TOTAL: 2 Peer(s) Found.
2.4 Configuring a Remote LDP Session
The remote LDP session is set up between two indirectly connected LSRs or directly connected
LSRs.
2.4.1 Establishing the Configuration Task
Before configuring a remote LDP session, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the data required for the configuration.
Pre-configuration Tasks
Before configuring a remote LDP session, complete the following task:
Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS 2 MPLS LDP Configuration
Issue 01 (2011-12-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
29