Huawei AR1200 Series - Page 35

Example
Run the display mpls interface command to view information about all MPLS-enabled
interfaces.
<Huawei> display mpls interface
Interface Status TE Attr LSP Count CRLSP Count Effective MTU
GE1/0/0 Up Dis 0 0 1500
Run the display mpls ldp command to view global LDP information, including timers.
<Huawei> display mpls ldp
LDP Global Information
--------------------------------------------------------------------------
Protocol Version : V1 Neighbor Liveness : 600 Sec
Graceful Restart : Off FT Reconnect Timer : 300 Sec
MTU Signaling : On Recovery Timer : 300 Sec
Capability-Announcement : On Longest-match : On
LDP Instance Information
--------------------------------------------------------------------------
Instance ID : 0 VPN-Instance :
Instance Status : Active LSR ID : 4.4.4.4
Loop Detection : Off Path Vector Limit : 32
Label Distribution Mode : Ordered Label Retention Mode : Liberal
Instance Deleting State : No Instance Reseting State : No
Graceful-Delete : Off Graceful-Delete Timer : 5 Sec
--------------------------------------------------------------------------
Run the display mpls ldp interface [ verbose ] command to view LDP-enabled interface
information, including transport addresses and timers.
<Huawei> display mpls ldp interface
LDP Interface Information in Public Network
Codes:LAM(Label Advertisement Mode), IFName(Interface name)
A '*' before an interface means the entity is being deleted.
------------------------------------------------------------------------------
IFName Status LAM TransportAddress HelloSent/Rcv
------------------------------------------------------------------------------
GigabitEthernet1/0/0 Active DU 172.17.1.1 2495/2514
------------------------------------------------------------------------------
<Huawei> display mpls ldp interface verbose
LDP Interface Information in Public Network
------------------------------------------------------------------------------
Interface Name : GigabitEthernet1/0/0
LDP ID : 1.1.1.1:0 Transport Address : 1.1.1.1
Entity Status : Active Effective MTU : 1500
Configured Hello Hold Timer : 15 Sec
Negotiated Hello Hold Timer : 15 Sec
Configured Hello Send Timer : 2 Sec
Configured Keepalive Hold Timer : 45 Sec
Configured Keepalive Send Timer : 3 Sec
Configured Delay Timer : 0 Sec
Label Advertisement Mode : Downstream Unsolicited
Hello Message Sent/Rcvd : 29913/29878 (Message Count)
Entity Deletion Status : No
------------------------------------------------------------------------------
Run the display mpls ldp session [ verbose ] command. The command output shows that the
LDP session status is Operational.
<Huawei> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS 2 MPLS LDP Configuration
Issue 01 (2011-12-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28