# Configure LSRC.
<LSRC> system-view
[LSRC] mpls lsr-id 3.3.3.9
[LSRC] mpls
[LSRC-mpls] quit
[LSRC] mpls ldp
[LSRC-mpls-ldp] quit
Step 3 Enable MPLS on interfaces of every LSR.
# Configure LSRA.
[LSRA] interface gigabitethernet 1/0/0
[LSRA-GigabitEthernet1/0/0] mpls
[LSRA-GigabitEthernet1/0/0] quit
# Configure LSRB.
[LSRB] interface gigabitethernet 1/0/0
[LSRB-GigabitEthernet1/0/0] mpls
[LSRB-GigabitEthernet1/0/0] quit
[LSRB] interface gigabitethernet 2/0/0
[LSRB-GigabitEthernet2/0/0] mpls
[LSRB-GigabitEthernet2/0/0] quit
# Configure LSRC.
[LSRC] interface gigabitethernet 1/0/0
[LSRC-GigabitEthernet1/0/0] mpls
[LSRC-GigabitEthernet1/0/0] quit
Step 4 Enable LDP on interfaces where local LDP sessions are to be established.
# Configure LSRA.
[LSRA] interface gigabitethernet 1/0/0
[LSRA-GigabitEthernet1/0/0] mpls ldp
[LSRA-GigabitEthernet1/0/0] quit
# Configure LSRB.
[LSRB] interface gigabitethernet 1/0/0
[LSRB-GigabitEthernet1/0/0] mpls ldp
[LSRB-GigabitEthernet1/0/0] quit
[LSRB] interface gigabitethernet 2/0/0
[LSRB-GigabitEthernet2/0/0] mpls ldp
[LSRB-GigabitEthernet2/0/0] quit
# Configure LSRC.
[LSRC] interface gigabitethernet 1/0/0
[LSRC-GigabitEthernet1/0/0] mpls ldp
[LSRC-GigabitEthernet1/0/0] quit
Step 5 Verify the configuration.
After completing the preceding configurations, run the display mpls ldp session command on
every LSR. The status of each local LDP session between LSRA and LSRB, and LSRB and
LSRC is Operational.
In the following example, the display on LSRA is used.
<LSRA> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status LAM SsnRole SsnAge KASent/Rcv
Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS 2 MPLS LDP Configuration
Issue 01 (2011-12-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
74
To Next Page
Loading...
