Huawei AR1200 Series - Logging in to the Devices Through the Console Port

[LSRC] mpls lsr-id 3.3.3.9
[LSRC] mpls
[LSRC-mpls] quit
[LSRC] mpls ldp
[LSRC-mpls-ldp] quit
Step 3 Specify a remote LDP peer and its IP address on two LSRs at both ends of a remote LDP session.
# Configure LSRA.
[LSRA] mpls ldp remote-peer LSRC
[LSRA-mpls-ldp-remote-lsrc] remote-ip 3.3.3.9
[LSRA-mpls-ldp-remote-lsrc] quit
# Configure LSRC.
[LSRC] mpls ldp remote-peer LSRA
[LSRC-mpls-ldp-remote-lsra] remote-ip 1.1.1.9
[LSRC-mpls-ldp-remote-lsra] quit
Step 4 Verify the configuration.
# After completing the preceding configurations, run the display mpls ldp session command
on each LSR. The command output shows that the remote LDP session between LSRA and
LSRC is in the Operational state.
In the following example, the display on LSRA is used.
[LSRA] display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status LAM SsnRole SsnAge KASent/Rcv
------------------------------------------------------------------------------
3.3.3.9:0 Operational DU Passive 0000:00:01 6/6
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
# Run the display mpls ldp remote-peer command on each LSR to view remote LDP peer
information.
In the following example, the display on LSRA is used.
[LSRA] display mpls ldp remote-peer
LDP Remote Entity Information
------------------------------------------------------------------------------
Remote Peer Name : LSRC
Remote Peer IP : 3.3.3.9 LDP ID : 1.1.1.9:0
Transport Address : 1.1.1.9 Entity Status : Active
Configured Keepalive Hold Timer : 45 Sec
Configured Keepalive Send Timer : ---
Configured Hello Hold Timer : 45 Sec
Negotiated Hello Hold Timer : 45 Sec
Configured Hello Send Timer : ---
Configured Delay Timer : 0 Sec
Hello Packet sent/received : 10/7
Remote Peer Deletion Status : No
Auto-config : ---
------------------------------------------------------------------------------
TOTAL: 1 Peer(s) Found.
----End
Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS 2 MPLS LDP Configuration
Issue 01 (2011-12-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78