Huawei Technologies Proprietary
14
Click Cancel to quit configuration without saving the
changes.
Click Next to display the Connection Type page.
For the parameter explanation of the Connection Type page,
see Table 3-2.
Click Back to go back to the previous page.
Click Cancel to quit configuration without saving the
changes.
Click Next to display the WAN IP page.
Table 3-4 shows the parameter explanation of the WAN IP page.
Table 3-4 Parameters in the WAN IP page
Item Configuration
The Access
Configurator
Option
Check the box to enable the access configuration
option.
Access
Concentrator
Enter the IP address of the access concentrator.
WAN IP Settings
If you select Obtain an IP address
automatically, system will obtain an IP address
automatically from remote DHCP server.
If you select use the following IP address, you
will need to enter the IP address provided by
your ISP.
WAN IP Address
Enter the IP address of WAN interface provided by
your ISP.
Enable NAT
You can check the box to enable NAT or leave it
unchanged to disable NAT.
Add Default Route
You can check the box to enable adding default
route or leave it unchanged to disable it.
Click Back to go back to the previous page.
To Next Page
Loading...
Need help?
General