— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment
and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and
operated in accordance with provided instructions and the antenna(s) used for this transmitter must
be installed to provide a separation distance of at least 20cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter. End-users and installers
must be provide with antenna installationinstructions and consider removing the no-collocation
statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FAQs
The LOS indicator blinks.
� If the LOS indicator blinks once two seconds, check whether the pigtail fiber is properly connected
and the connector is clean.
� If the GPON terminal blinks twice a second, contact the service provider for help.
The PON indicator is off.
� Check whether the OPTICAL port and optical fiber is properly connected.
� The GPON terminal fails to register with the upper-layer device. Contact the service provider for
help.
The phone does not ring upon an incoming call but communication is in normal state
when the phone is in off-hook state.
� The GPON terminal provides a maximum of 60 V AC ringing current
voltage. Check whether the ringing current voltage of the phone is higher
than 60 V AC. If it is higher than 60 V AC, replace it with another phone.
How to reset the GPON terminal?
� Press Reset by using a needle-type object.
How can I restore factory defaults?
� Press Reset by using a needle-type object for longer than 10s to restore
factory defaults and reset the GPON terminal. If the indicator is off and then is lit, the system
restarts successfully.
To Next Page
Loading...
Need help?
General
