Huawei EG8010H - Connecting Power and ON;OFF; LAN and Optical Port Connections; Reset Functionality

NO TE
● The ber connector connected to the optical port on the wall varies depending on
actual conditions.
● To ensure normal use of bers, make sure that the ber bending radius is larger than 30
mm.
No. Item Description
1 ON/OFF Powers the ONT on or o.
2 POWER Connects to a power adapter.
3 LAN Connects to PC or IP set-top box (STB).
4 OPTICAL The optical port is equipped with a rubber plug and
connected to a ber for upstream transmission.
The type of the optical connector connected to the
optical port can be SC/APC.
5 Reset Press the button for a short time to reset the device; or
press the button for a long time (longer than 10s) to
restore the device to the default settings and reset the
device.
NOTE
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail
to access the Internet. If an ONT cannot access the Internet
after a reset, contact your Internet service provider.
EG8010H
Quick Start for QR code 2 Connecting Cables
Issue 04 (2020-07-21) Copyright © Huawei Technologies Co., Ltd. 4