Huawei HG532D - Modem Configuration Guide Manual

1
Modem Conguration Guide
HG532D
Conguring in Layer2 PPPoE for Windows XP and 2000
IMPORTANT MESSAGE
Your modem has been pre-configured, you do not need to follow each step of the set-up guide but should retain this
document in case you need to manually configure your equipment.
To configure your PC/Laptop with your wireless password including changing your wireless password, please
proceed to step 4.
Contents
1. Physical Connection
2. Network Configuration
3. Configuring Internet
4. Configuring Wireless
5. IPTV
6. Change of Password
1. PHYSICAL CONNECTION
Have your router powered on and connected directly to your PC via Ethernet Cable before you begin, as these
instructions are based on wired Ethernet connection
2. NETWORK CONFIGURATION
PPPoE connection does not require you to have an IP address or DNS settings manually encoded on your network card.
PPPoE connection uses authentication to establish the Internet connection and once connected your modem will be
assigned an IP and DNS settings from TPG.
To begin, your PC needs to receive a private IP address from the router. Most ADSL routers have DHCP enabled by
default that will take care of this.
To ensure your Network Card is ready for this, please follow the following steps:
A. Click Start -> Settings -> Control Panel -> Network Connections
B. Right click on Local Area Connection and select Properties
HG532D