7 Installing a Day & Night High Speed Dome IPC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Figure 7-4 Fastening the thumb screw
Step 8 Install the assembled high-speed dome IPC on the wall and fasten the four screws.
----End
Installing the IPC on the Wall When Type-2 Bracket Is Used
Step 1 Keep the transparent dome of the IPC upward. Rotate the dome anticlockwise to open the
dome. Take out the foam and remove the protective film on the transparent dome. Then,
rotate the dome clockwise to install the dome.
Step 2 Determine the positions of installation holes based on the installation dimensions of the
bracket and mark the holes. Use a percussion drill bit with a diameter of 8 mm to drill four
holes that are 60 mm deep. Figure 7-5 shows the installation dimensions (in the unit of mm)
of the bracket.
To Next Page
Loading...