Huawei IPE Series - Page 85

IPE
Installation Guide
8 Installing an Infrared High Speed Dome IPC
Issue 03 (2013-02-28)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
78
Tool
Appearance
Remark
Flat-head
screwdriver
L-Wrench
Screw
Delivered with the
bracket
8.2 Installation Mode
You can install the high speed dome IPC on either the wall or ceiling.
CAUTION
If the IPC is installed on a hard wall indoors or outdoors, the installation environment must
meet the following conditions:

The wall is thick enough to install the expansion bolts.

The wall can bear at least eight times of the total weight of the IPC and bracket.

The protective film of the dome can be removed only after the installation is complete.
During the installation, ensure that the dome is clean. Do not touch the dome directly
using hands or other objects. Otherwise, the image quality is affected.
8.3 Installation Procedure
8.3.1 Installing the IPC on the Wall
If the IPC is installed on the wall, two types of brackets can be used. The following section
describes the installation procedures when the two types of brackets are used.