8
3. Wear insulation gloves and install copper bars between battery packs.
•
Use the copper bars delivered with the ESS. Do not use copper bars from ESSs of different
models.
•
When installing a nut, manually insert the nut into the screw plate, and then use a socket
wrench to completely secure the nut in place. This prevents the screw thread from being
stuck or stripped due to the deviation of the nut position.
•
Pre-install nuts according to the recommended torque of 27 N·m.
•
Verify that the torque of the installed nuts is 27 N·m using a torque wrench.
•
Mark the nuts whose torque has been verified using a marker.
•
Use an extension rod for the torque wrench.
Three types of copper bars are included with the equipment and are identified by the
silkscreens A, B, and C printed on the front.
When installing copper bar C,
keep away from
communications cables and
fan power cables of battery
packs to prevent cables from
being squeezed.
To Next Page
Loading...
